Step 1. Use your key to turn on your ignition switch. You can find your switch beside the steering wheel, which has four positions: that is the on, off, start and accessories. Though some cars have two off positions, the first one lets your key to be removed from the car ignition system while the second lets you turn off the car. Leave the ground and just wrap it up once done. Disconnect your battery before installing the resistor. Once everything is wrapped back up, with resistors installed, hook battery back up and you should be good and hopefully without an A/B light. If there is an A/B light, something was installed incorrectly.
This video shows how to remove the parking brake switch in a Volkswagen Golf mk4. The part number for the switch is 1J0947561.
WARNING this is no repair manualhow to disable check airbag on VW Golf 5 side seat airbag#VWAirbagResistor2ohm or 3ohm or 4ohm vw airbag resistor.
You can find parts and tools used in this video here: TechStream OBD2 cable: The bulb failure warning light has been annoying me for about two weeks. The warning light can be ON for 30min, then automatically OFF for a couple of hours, then ON again. I checked all exterior lights when the warning light was ON: headlights (low and high beam), parking lights, turning lights, braking lights, and rear night lights were all OK. wO4ehzn. 422 277 446 430 120 90 453 134 242

how to turn off airbag light vw golf mk4